New KinskyPronto for Davark

[Luis]

Hi I have couple of questions regarding the new DS for Phillips Pronto

1. Is there any way to set 2 different DS (KDS & MDS-I) on it? Cause now you put the parameters on the home page and not on the individual ds like before.

2. Also, can I integrate the *.xcf file with my current configuration file? I ask cause before I was able, but when I did now, everything works fine except no coverart shows.

Thanks

[rockfather Linn Staff]

(2011-05-09 23:34)Luis Wrote:  Hi I have couple of questions regarding the new DS for Phillips Pronto

1. Is there any way to set 2 different DS (KDS & MDS-I) on it? Cause now you put the parameters on the home page and not on the individual ds like before.

2. Also, can I integrate the *.xcf file with my current configuration file? I ask cause before I was able, but when I did now, everything works fine except no coverart shows.

Thanks

Firstly, the Davaar release of Pronto functions identically to the last Cara release except for library browsing enhancement, so the points you raise are equally valid/invalid with the last Cara release

Point 1 - there is no way to configure 2 different DS players on the device. As Pronto is a room controller which has to be programmed for every specific piece of equipment in a room there should be no need to support multiple players.

Point 2 - have not tried this, but should work the same as the last Cara version

[Rik]

Hi.

1: Yes - quite easy. How you do it exactly would depend on your set-up but you could use a set f buttons of pages to swap between DSs.

2: Not sure - don't see why not buy will investigate.

Rik